Modine PDP150LP Manuál s instrukcemi stáhnout pdf

THIS MANUAL IS THE PROPERTY OF THE OWNER.

PLEASE BE SURE TO LEAVE IT WITH THE OWNER WHEN YOU LEAVE THE JOB.

Inspection on Arrival

1. Inspect unit upon arrival. In case of damage, report it

immediately to transportation company and your local

Modine sales representative.

Check rating plate on unit to verify that power supply meets

available electric power at the point of installation.

3. Inspect unit upon arrival for conformance with description of

product ordered (including specifications where applicable).

Table of Contents

Inspection on Arrival ................................. 1

Special Precautions ................................. 2

SI (Metric) Conversion Factors ........................ 3

Before You Begin . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3

Unit Location ...................................... 4

Combustible Material and Service Clearances .......... 4

Unit Mounting .................................... 5

Installation ........................................ 6

Venting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6

Gas Connections ................................ 10

High-Altitude Accessory Kit .........................11

Electrical Connections ............................ 13

Operation ...................................... 14

Unit Components .................................. 15

Performance Data - General ......................... 15

Performance Data - Downturn Hoods .................. 16

Dimensions....................................... 17

Service/Maintenance/Troubleshooting .................. 18

Model/Serial Number/Replacement Parts ............... 19

Commercial Warranty........................Back Cover

INSTALLATION AND SERVICE MANUAL

power vented gas-fired unit heaters

model PTP

6-560.4

5H0801050000

November, 2014

All models approved for use in California by the CEC and in

Massachusetts. Unit heater is certified for non-residential

applications.

1. Improper installation, adjustment, alteration,

service, or maintenance can cause property

damage, injury, or death, and could cause

exposure to substances which have been

determined by various state agencies to

cause cancer, birth defects, or other

reproductive harm. Read the installation,

operating, and maintenance instructions

thoroughly before installing or servicing

this equipment.

2. Do not locate ANY gas-fired units in areas

where chlorinated, halogenated, or acidic

vapors are present in the atmosphere.

These substances can cause premature

heat exchanger failure due to corrosion,

which can cause property damage, serious

injury, or death.

FOR YOUR SAFETY

WHAT TO DO IF YOU SMELL GAS:

1. Open windows.

2. Do not try to light any appliance.

3. Do not touch any electrical switch; do

not use any phone in your building.

4. Extinguish any open flame.

5. Immediately call your gas supplier from

a neighbor’s phone. Follow the gas

supplier’s instructions. If you can not

reach your gas supplier, call your fire

department.

FOR YOUR SAFETY

The use and storage of gasoline or other

flammable vapors and liquids in open containers

in the vicinity of this appliance is hazardous.

The use of this manual is specifically intended

for a qualified installation and service agency.

All installation and service of these units

must be performed by a qualified installation

and service agency.

ARNING

IMPORTANT

1 2 3 4 5 6 ... 19 20

Shrnutí obsahu

Strany 1 - Inspection on Arrival

THIS MANUAL IS THE PROPERTY OF THE OWNER. PLEASE BE SURE TO LEAVE IT WITH THE OWNER WHEN YOU LEAVE THE JOB. Inspection on Arrival1. Inspect unit upo

Strany 2 - SPECIAL PRECAUTIONS

106-560.4INSTALLATION - GAS CONNECTIONSGAS CONNECTIONS1. Installation of piping must conform with local building codes, or in the absence of local co

Strany 3 - BEFORE YOU BEGIN

116-560.4INSTALLATION - HIGH ALTITUDE ACCESSORY KITHIGH ALTITUDE ACCESSORY KITAltitude (ft)Gas Heating Values at Altitude (BTU/ft3)USA Canada0-2,000 1

Strany 4 - UNIT LOCATION

126-560.4INSTALLATION - HIGH ALTITUDE ACCESSORY KITIf the heating value of the gas being supplied is different than the values shown in Tables 11.1 an

Strany 5 - UNIT MOUNTING

136-560.4INSTALLATION - ELECTRICAL CONNECTIONS Amp draw data shown is operating amp draw at incoming power. For units that use a field installed acce

Strany 6 - INSTALLATION - VENTING

146-560.4INSTALLATION - OPERATIONAlthough this unit has been assembled and fire-tested at the factory, the following pre-operational procedures should

Strany 7

156-560.4CONTROL OPERATING SEQUENCE / UNIT COMPONENTSUpon a call for heat from the thermostat, power is supplied to the power exhauster motor. The uni

Strany 8

166-560.4Figure 16.1 - 30°, 60°, and 90° Downward Deflector Hoods HSSMOUNTINGHEIGHTXYYZZX60 DOWNTURN30 DOWNTURNNote:X = Feet from Heater to Start of

Strany 9

176-560.4DIMENSIONAL DATA - MODEL PTPPropeller Units - Model PTPFigure 17.1 - Dimensional Drawings A F H B POWER VENTERVENT PIPE CONNECTIONACCESS

Strany 10 - GAS CONNECTIONS

186-560.4SERVICE / MAINTENANCE / TROUBLESHOOTINGGeneral MaintenanceThe unit and venting system must be checked once a year by a qualified service tech

Strany 11 - HIGH ALTITUDE ACCESSORY KIT

196-560.4Model SizePower ExhausterLimit Control Switch Pressure SwitchIgniterIgnition Control (1 Stage)Combination Gas Valve (1 Stage)Ignition

Strany 12

26-560.4SPECIAL PRECAUTIONSSPECIAL PRECAUTIONSTHE INSTALLATION AND MAINTENANCE INSTRUCTIONS IN THIS MANUAL MUST BE FOLLOWED TO PROVIDE SAFE, EFFICIEN

Strany 13 - ELECTRICAL CONNECTIONS

Modine Manufacturing Company1500 DeKoven AvenueRacine, WI 53403 Phone: 1.800.828.4328 (HEAT) www.modinehvac.com© Modine Manufacturing Company 2014As M

Strany 14 - INSTALLATION - OPERATION

6-560.4In the U.S., the installation of these units must comply with the National Fuel Gas Code, ANSI Z223.1 (NFPA 54) - latest edition and other appl

Strany 15

6-560.4Location Recommendations1. When locating the heater, consider general space and heating requirements, availability of gas and electrical suppl

Strany 16 - 60 DOWNTURN

56-560.41. Be sure the means of suspension is adequate to support the weight of the unit (see page 17 for unit weights). 2. For proper operation,

Strany 17 - DIMENSIONAL DATA - MODEL PTP

66-560.4A4. Refer to Table 6.1 for total minimum and maximum vent lengths, making the system as straight as possible. The equivalent length of a 90°

Strany 18 - General Maintenance

6-560.4A9. When the vent passes through a combustible INTERIOR wall or floor, a metal thimble 4" greater than the vent diameter is necessary

Strany 19 - Replacement Parts

86-560.4Section B – Vertical Vent System InstallationB1. This section applies to vertically vented Category I vent systems and is in addition to “Sect

Strany 20 - COMMERCIAL WARRANTY

96-560.4Section C – Horizontal, Category III Vent System InstallationC1. This section applies to horizontally vented Category III vent systems and is

Komentáře k této Příručce

Žádné komentáře

Modine PDP150LP Manuál s instrukcemi

Procházejte online nebo si stáhněte Manuál s instrukcemi pro Krby Modine PDP150LP. Modine PDP150LP Instructions / Assembly Uživatelská příručka

Shrnutí obsahu

Komentáře k této Příručce